Bioloid Bus Devices

All these bus device boards can be daisy-chained along with the AX-12s of a Bioloid robot.

IMU-01 : $50 USD

This package includes the IMU board pictured to the left, plus the mounting and assembly hardware required to build it once you supply the sensor boards.

This IMU board is a Bioloid bus device, and is fully compatible with the CM-5 controller.

Fully Assembled 6-Axis IMU, with Sensors

IMU-02 : $250 USD

This package includes the IMU Board package (IMU-01) plus the two sensor boards. It comes fully assembled, and ready to install into a stock Bioloid humanoid chest compartment.

FSR-01 : $75 USD (available soon)

This package includes one of the boards shown to the left, four pressure sensors designed to be attached to the Bioloid foot, and the wiring necessary to connect the sensors to the board.

Bioloid Accessory Boards

USB-01 : $60 USD

This package includes one of the boards shown to the left, plus a spare five amp fuse. This board allows your PC to communicate with Bioloid bus devices (AX-12, AX-S1, IMU, etc) using a USB cable (not included) at speeds of up to 1.0 Mbps.

The design and development of these devices was funded by The Neukom Institute.

Eventually, these pages will be replaced by a proper store.

All prices do not include shipping. If the parts are being shipped to somewhere in Canada, you will be charged 6% GST. If the parts are being shipped to Ontario, you will be charged 6% GST and 8% PST.

Shipping is by Canada Post Xpresspost, unless other arrangements are made.

To purchase any of these items, please - include which items you want, how many of each, and the address you want them shipped to. We will respond with a quote for the items plus shipping and tax (if applicable). All payments must be made through PayPal.